1PCS Tester Lab Roller Type Coating Surface Wet Film Thickness Wheel Gauge Meter

Description: Lab Roller Type Coating Surface Wet Film Thickness Wheel Gauge Meter Tester Purpose and overview: The instrument is in accordance with international standards ISO2808-1974E Paint and varnish-Film thickness determination of the requirements and the design and manufacture of, mainly used for coating the surface of the wet film thickness determination and roughly estimate roughly the thickness of dry film, the instrument that can be used in laboratory and used for production control. Specifications: Measurement range: 0~50um, 0~100um, 0~150um, 0~200um, 0~500um, 0~1000um Index value: 30um, 15um, 20um, 10um Use and operation method: The paint is coated on the suitable hardness flat plate (rigid base material), the area of the test plate must be large enough, so that the distance between the film thickness measurement point and the test plate is at least.25mm, the thickness of the wet film was determined immediately after coating. And the test plate fixed on an appropriate level of foundation, so in the determination of the film in the process of test plate will not produce a moving or bouncing, the instrument on the wet film thickness to be measured, so that the minimum reading at the top, and instruments of the eccentric wheel and the wet film between maximum gap just to the right of the wet film party, then the rolling forward and a half weeks (180(degree) and reverse the direction of repeated rolling half a week180Mobile DEG), check the instrument the central flange and wet membrane on the surface of the first contact position read reading and the average value was calculated as a reading. And if topcoats contain quick volatile solvent or the solid content is low, then the best in just painted a good film, and at least take a separate reading and calculation these separate readings of the average value. Note: Although the instrument was applied to the determination of coated flat test plate of wet film thickness, but on site or in the factory can also used only to a direction of bending the workpiece surface, as long as the bottom material between the two concentric round bend curved even affect the instrument determination can be.

Price: 89 USD

Location: CN

End Time: 2025-01-01T07:13:20.000Z

Shipping Cost: 18.25 USD