Description: These are 4 pieces Brand New replacement upper and lower Polyurethane belt set. Teeth on only one side. -Color may vary. Upper belt is about 14 1/4" (362mm) circumfrence lower belt is about 12" (300mm) circumfrence. Top width: 5.5mm ,Bottom width: 4mm ,Height :3.5mm ,Angle :40° for Kenmore models: 158. 12110, 158.12111, 158.12112, 158.12120, 158.12121, 158.12310, 158.12311, 158.12312, 158.12313, 158.12410, 158.12411, 158.12412, 158.12472, 158.12510, 158.12511, 158.12512, 158.12520, 158.13410, 158.13411, 158.13412, 158.13413, 158.13414, 158.13513, 158.13580, 158.13581, 158.16800, 158.16801, 158.16900, 158.17800, 158.18800, for Kenmore models: 385.10111, 385.11541, 385.11551, 385.11581, 385.12320, 385.12321, 385.12331, 385.12332, 385.12490, 385.12491, 385.12492, 385.12493, 385.12541, 385.12641, 385.12741, 385.12841 Determine what size belt your machine requires Step 1 - Remove old belt if still attached to machine. Step 2 - Adjust motor to center position. Most sewing machine motors have a bolt or screw that holds the motor in place. When this bolt or screw is loosened, the motor will move in two directions. Loosen this screw and move the motor to center position and re-tighten the bolt or screw. The reason for this step is so that you will have about 1/2" worth of adjustment for the new belt. Step 3 - Take a piece of non-stretchable string and run it around the machine's hand wheel and motor pulley. Be sure that the string is inside of the belt groove of the hand wheel and pulley. Step 4 - Cut the string so that two ends meet. This will tell you what size of belt you will need. Step 5 - Remove the string from the machine and lay it flat and straight on a table. Using a measuring device, measure the complete length of the cut string. Now you will know what size of belt to order. For example, if the string measures 16 1/2" long, then you will need a 16 1/2" belt. Once the new belt has arrived, you simply loosen the bolt or screw that is holding the motor in place. Then attach the belt around the hand wheel and pulley. Make sure the belt is inside the belt grooves. You may have to lift or adjust the motor slightly in order to get a good fit. Once the belt is in place, simply apply a little down pressure on the motor while tightening the bolt or screw. The belt should be tight enough so that it doesn't slip, but not too tight so that it puts strain on the motor. Loosen the motor bolt/screw and adjust the belt tension as needed
Price: 8.39 USD
Location: Wuhan
End Time: 2024-11-17T14:33:49.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Return shipping will be paid by: Seller
All returns accepted: Returns Accepted
Item must be returned within: 60 Days
Refund will be given as: Money back or replacement (buyer's choice)
Craft Type: sewing
MPN: BELT-KM385-2
Country/Region of Manufacture: Taiwan
Compatible Brand: Universal, For Baby Lock, For Bernina, For Brother, For Consew, For Elna, For Husqvarna Viking, For Janome, For Juki, For Kenmore, For Singer
Brand: evernice
Type: Motor Belt
