48 Volt 1000 Watt Brushed Controller ONLY 48v 1000w Top Quality

Description: ATTENTION--This will not plug into ANY razor product with the stock throttle You Must Have one of my throttles with this, and even if you have my throttle you must ad a note at checkout and a message direct after stating you have my throttle or you will be swapping wires on your throttle , from me, to make it work,,this is controller has 4 pin connector for a throttle!AGAIN this controller will not plug into the factory throttle of any razor product and it dont matter how many pins it has IT WILL NOT PLUG INTO A FACTORY RAZOR THROTTLE!! 1000 Watt -48V 30amp Brushed Motor Variable Speed Controller If your motor has more than 2 wires coming out of it its not a brushed motor and NO this wont and cant work. No it wont work with a 1800 watt motor because its not a brushed motor, this is brushed only and taps at a 1000watts Take note -- Comes with 4 pin connector for your existing throttle (must check voltages on each wire on your end prior to connecting),on/off connector,charger connector,motor connector and brass ends. Everything you will need to hook it up and directions! You CAN NOT just plug in any throttle to this controller without knowing what each wire on your existing throttle is for. If you do, you will fry both controller and throttle. Directions explain what each of my controllers wires are for and they must match. If you have one of my throttles with keys or on off button simply request this with a 6 pin connector for the throttle and it will come in the proper order that we send our throttles connectors out in. Don't try and guess what goes where like others listed, we clearly state what is what. 1000 Watt - 48V Controller. These controllers we had made specificly for durability. We use them in our variable speed kits for the Razor Scooters and many other custom kits we make here at overvoltedscooters.. This controller is for brushed (Also known as "PM" or "Magnet" motors, which will only have 2 wires coming from the motor). Low Voltage Cut-Off=41.5. Great controller, durable and long lasting. For the price you can't go wrong and we use these on our custom builds so they WORK. Be sure to check out our store for a wide selection of top quality scooter parts! This comes normally wired like this but we can set it up to your needs.. 2 wire connector red and black-Charger port 4 wire female connector black=Negative,red=4.6v to throttle,green=0-5v from throttle and Red with Black Stripe=48+volts(for display only)-Common 4 wire throttle with display 2 wire female connector black and yellow-Optional Cut off for brake switch for front or rear 2 wire female connector black and yellow-Optional Cut off for brake switch for front or rear 3 wire female connector black and red-Optional brake lights 2 wire female connector red and blue-Power switch or key on/off (ground wire is optional will use to run a light on switch if needed) 2 wire male connector red and black-Battery wires 2 wire female connector blue and yellow-Motor Wires Most controllers in 48v 1000 watt ,as you most likely know, do not have this many options to plug right in and thats why this controller is so user friendly...If you need a matching standard throttle,5 LED throttle or throttle with key,,simply purchase which one you want and It will come with a connector ready to plug in..

Price: 32.95 USD

Location: Sarasota, Florida

End Time: 2024-08-03T16:35:52.000Z

Shipping Cost: 7.35 USD