BG BARRY GRANT 400 FUEL PUMP SEAL KIT AND FITTING ORING NOK BLACK ONLY

Description: Please pull your pump down prior to purchase and make sure it has the black all rubber nok seal in it.This is a deluxe reseal kit for the Barry Grant BG400 and BG400-2 fuel pump. Included in this kit is the nok shaft seal from the original BG vendor as well as the correct BUNA rated end plate o-ring. Also included are the two -10an orings for the inlet and outlet fittings, the -8an oring that goes onto the adjustable bypass where it screws into the pump body and 2 of the inner orings for the adjustable bypass. *some have asked why we supply 2 of the inner orings for the bypass as it only uses 1 but the inner body is machined with 2 sets of grooves and the oring has to sit in the second set in. Some have found it easier to put one of the orings in the first channel so the second oring passes it easier while others have cut one trying to get it past the groove. We figure given the inexpensive cost of the orings this just makes the install easier for the racer.Any questions feel free to email us. Please note these work on pumps produced up until early 2006 that have the rubber shaft seals. During 2006 there was a production change to the pumps as well as some repaired pumps and they will have the larger walrus seal in them which can be identified by its brown color and hard outer shell.These will not replace the walrus seals in those pumps. This kit is also different from the 220/280 kit as the end plate o-ring is different even though some sellers show the same kit. We do have the correct kits for the 220/280 listed as well. Quick shipping daily by First Class USPS . International shipping available as well. WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Price: 19.95 USD

Location: Gainesville, Georgia

End Time: 2024-09-09T23:04:59.000Z

Shipping Cost: 0 USD