Description: Good used easy to install preamp. The PR6 is a high-performance, low-noise 6-meter preamp that can be used with the Elecraft K3 or other transceivers. It's especially well-suited to the K3, which has exceptional dynamic range, yet can benefit from additional gain for 6-meter weak signal work. Adding the PR6 typically improves 6-meter MDS from about -136 to -143 dBm. The noise figure of the preamp itself is typically 0.5 dB. The PR6 can be connected directly to the RX ANT IN/OUT jacks on the K3's KXV3 module (required), where it can be switched in automatically by the transceiver when operating on 6 meters. A second pair of jacks is provided on the opposite side of the PR6 to allow use of the K3's normal RX ANT IN/OUT signal path when the preamp is not in use. Power for the PR6 can be obtained from any 11 to 14 VDC supply. When used with a K3, the PR6 can be powered from the 12 VDC accessory output. It can be strapped permanently ON, or it can be turned on/off externally from an open-source/open-drain logic signal. In the K3 case, the DIGOUT1 control line can be used (on the 15-pin ACC jack), since it is stored on a per-band basiI have many Elecraft items, so if you need one,please email me.Larry K6RO
Price: 115.99 USD
Location: Temecula, California
End Time: 2024-12-01T22:18:21.000Z
Shipping Cost: 6.99 USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Compatible Brand: For Elecraft
Brand: Elecraft
Type: Cables & Adaptors
Band: AM, FM, HF
