Inzer HPHD Bench shirt - Red w white and yellow lettering (Good training shirt)

Description: Compare to $77 new. This shirt is used and has two minor defects. There is a professionally repaired 2.25 inch runner on the left chest panel which crosses over to the left sleeve (picture 2). There is a small 1.25 inch run on the right sleeve. I have included pictures of measurements. Shirt was worn by 5'9", 198 pound lifter. HOW TO MEASURE FOR SHIRTS Measure your shoulder circumference by stretching a tape measure all the way around the circumference of your body at shoulder level, at the point where your deltoids are most prominent. Measure your chest circumference directly under your arm pits above nipples. Measure your arm/bicep circumference at the largest part. All measurements should be taken relaxed and unflexed.BENCH SHIRTS AND ERECTOR SHIRTS To choose your own size in Erector Shirts, Standard Blast Shirt, HD Blast, HPHD, EHPHD and PHENOM: For first time users it is recommended that you add 2 to your shoulder circumference measurement to get your shirt size. For example, if your shoulder circumference is 50, 50 + 2 = 52. Or you may add 9 to your chest measurement to arrive at your shirt size. Choose whichever method gives you the smaller number for your shirt size. For most everyone else, your shoulder circumference measurement is your shirt size. You may choose to go a size smaller, however there is a chance it would be too tight for you. Steps above in Radical™ technology, the HPHD will enter you into the world of the more extreme designs. Made from quality, HD™ polyester material.Made from the same HD™ material as the Z Suit and Champion Suit, which will provide you with rebound and sturdiness of material.Extended power support range.New improved arm lock design.Excellent quality and support for upper level experience and performance.

Price: 25 USD

Location: Plano, Texas

End Time: 2025-01-25T22:04:00.000Z

Shipping Cost: 10 USD