Microprocessor Contactless Ignition System Ignition Coil HVW Ural Dnepr 6 12V

Description: General information The microprocessor-based contactless ignition system 1135.3734 and the ignition coil 135.3705M are designed to operate in the electrical system of 2-cylinder carburetor engines of Ural and Dnipro motorcycles of all modifications with 6 and 12-volt generators, instead of serial contact (PM302 chopper) and contactless ignition systems (sensor 17.3847, switch 47.3734). This kit includes high-voltage wires with distributed resistance, which allows you to get the maximum positive effect from the use of our microprocessor-based contactless ignition system on a motorcycle. Basic information The microprocessor-based contactless ignition system 1135.3734 (MICROPROCESSOR-BASED CONTACTLESS IGNITION SYSTEM) is an electronic switchboard with a microprocessor-controlled ignition timing and is designed to operate in the electrical system of 2-cylinder carburetor engines of the Ural and Dnepr, K-750 motorcycles instead of the serial contact ones (PM302 chopper) contactless (sensor 17.3847, switch 47.3734), inductive contactless ignition systems CONTACTLESS IGNITION SYSTEM 135.3734. The microprocessor-based contactless system is designed to improve the technical characteristics of a motorcycle due to: • increase engine power at low speeds; • reduction in fuel consumption; • improved cold start; • stability of the engine due to a decrease in the asynchrony of spark formation and optimization of the ignition timing depending on the engine speed; • reduction of toxicity of exhaust gases, fuel consumption and soot on candles due to an increase in the inductive phase of the spark; • sustainable engine starting when the battery voltage decreases; • reducing the complexity of installation and maintenance of the ignition system; • limiting the magnitude of the current and the time it flows through the primary winding of the ignition coil to prevent it from overheating and discharging the battery. The best spark discharge parameters are provided with coils 135.3705, 1135.3705, 135.3705М, however, the module is operable with any other motorcycle ignition coils (4412.3705, 406.3705, 3012.3705, 3022.3705). The electronic regulation of the moment of sparking used in the IPBSP ensures stable operation of the system in all normal operating modes of the motorcycle robot. Specifications • Nominal supply voltage of 6-12V with a grounded negative battery. • Current consumption when the ignition switch is turned on and the engine is idle does not exceed 0.15 A. • MPBSS provides uninterrupted sparking when the voltage in the electrical system changes from 6V to 16 V, while the voltage on the spark plugs does not change and reaches 17 kV. • MICROPROCESSOR-BASED CONTACTLESS IGNITION SYSTEM provides uninterrupted sparking at a crankshaft rotation speed of up to 7000 rpm, while the current consumption does not exceed 1.5 A. • The ignition system is operable in the range of ambient temperatures from -25 to +85 degrees C. MICROPROCESSOR-BASED CONTACTLESS IGNITION SYSTEM is mounted on a motorcycle using the fasteners included in the delivery. General information The ignition coil is designed to operate in a non-contact ignition system (CONTACTLESS IGNITION SYSTEM) in the electrical system of 2-cylinder carburetor engines of motorcycles of the Ural, Dnepr, IZh, Java types of all modifications. Coil 135.3705M is designed for motorcycles equipped with an electronic ignition system. The coil provides the best sparking parameters with CONTACTLESS IGNITION SYSTEM (contactless ignition system) and MICROPROCESSOR-BASED CONTACTLESS IGNITION SYSTEM (microprocessor ignition system) manufactured by SoveK LLC. The ignition coil 135.3705M operates both on motorcycles equipped with a 12-volt generator, and on motorcycles with a 6-volt generator. Technical details o Coil supply voltage with the negative terminal of DC sources connected to the motorcycle body: • minimum - 5V; • rated - 6V or 12V; • maximum - 16V. o Secondary voltage, with a burst current of 4A, shunt resistance 3MOhm, shunt capacitance 50Pf: • at a temperature of 25 ° C, at least - 18kV; • at a temperature of 85 ° C, at least - 16kV; o Burst current - 4A. o Resistance of the primary winding, Ohm - 0.80 ± 0.05; o Weight of the coil, kg, not more than 0.25; Overall dimensions, mm, no more - 97 × 45 × 58 LLC "SOVEK" Motocycle Parts Booking Now Microprocessor Contactless Ignition System Ignition Coil HVW Ural Dnepr 6 12V General information The microprocessor-based contactless ignition system 1135.3734 and the ignition coil 135.3705M are designed to operate in the electrical system of 2-cylinder carburetor engines of Ural and Dnipro motorcycles of all modifications with 6 and 12-volt generators, instead of serial contact (PM302 chopper) and contactless ignition systems (sensor 17.3847, switch 47.3734). This kit includes high-voltage wires with distributed resistance, which allows you to get the maximum positive effect from the use of our microprocessor-based contactless ignition system on a motorcycle. Basic information The microprocessor-based contactless ignition system 1135.3734 (MICROPROCESSOR-BASED CONTACTLESS IGNITION SYSTEM) is an electronic switchboard with a microprocessor-controlled ignition timing and is designed to operate in the electrical system of 2-cylinder carburetor engines of the Ural and Dnepr, K-750 motorcycles instead of the serial contact ones (PM302 chopper) contactless (sensor 17.3847, switch 47.3734), inductive contactless ignition systems CONTACTLESS IGNITION SYSTEM 135.3734. The microprocessor-based contactless system is designed to improve the technical characteristics of a motorcycle due to: • increase engine power at low speeds; • reduction in fuel consumption; • improved cold start; • stability of the engine due to a decrease in the asynchrony of spark formation and optimization of the ignition timing depending on the engine speed; • reduction of toxicity of exhaust gases, fuel consumption and soot on candles due to an increase in the inductive phase of the spark; • sustainable engine starting when the battery voltage decreases; • reducing the complexity of installation and maintenance of the ignition system; • limiting the magnitude of the current and the time it flows through the primary winding of the ignition coil to prevent it from overheating and discharging the battery. The best spark discharge parameters are provided with coils 135.3705, 1135.3705, 135.3705М, however, the module is operable with any other motorcycle ignition coils (4412.3705, 406.3705, 3012.3705, 3022.3705). The electronic regulation of the moment of sparking used in the IPBSP ensures stable operation of the system in all normal operating modes of the motorcycle robot. Specifications • Nominal supply voltage of 6-12V with a grounded negative battery. • Current consumption when the ignition switch is turned on and the engine is idle does not exceed 0.15 A. • MPBSS provides uninterrupted sparking when the voltage in the electrical system changes from 6V to 16 V, while the voltage on the spark plugs does not change and reaches 17 kV. • MICROPROCESSOR-BASED CONTACTLESS IGNITION SYSTEM provides uninterrupted sparking at a crankshaft rotation speed of up to 7000 rpm, while the current consumption does not exceed 1.5 A. • The ignition system is operable in the range of ambient temperatures from -25 to +85 degrees C. MICROPROCESSOR-BASED CONTACTLESS IGNITION SYSTEM is mounted on a motorcycle using the fasteners included in the delivery. General information The ignition coil is designed to operate in a non-contact ignition system (CONTACTLESS IGNITION SYSTEM) in the electrical system of 2-cylinder carburetor engines of motorcycles of the Ural, Dnepr, IZh, Java types of all modifications. Coil 135.3705M is designed for motorcycles equipped with an electronic ignition system. The coil provides the best sparking parameters with CONTACTLESS IGNITION SYSTEM (contactless ignition system) and MICROPROCESSOR-BASED CONTACTLESS IGNITION SYSTEM (microprocessor ignition system) manufactured by SoveK LLC. The ignition coil 135.3705M operates both on motorcycles equipped with a 12-volt generator, and on motorcycles with a 6-volt generator. Technical details o Coil supply voltage with the negative terminal of DC sources connected to the motorcycle body: • minimum - 5V; • rated - 6V or 12V; • maximum - 16V. o Secondary voltage, with a burst current of 4A, shunt resistance 3MOhm, shunt capacitance 50Pf: • at a temperature of 25 ° C, at least - 18kV; • at a temperature of 85 ° C, at least - 16kV; o Burst current - 4A. o Resistance of the primary winding, Ohm - 0.80 ± 0.05; o Weight of the coil, kg, not more than 0.25; Overall dimensions, mm, no more - 97 × 45 × 58 New CollectionSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWSHOP NOWPaymentShippingReturnsAbout Us Payment PaymentShippingReturnsAbout Us Payment We accept PayPal only We ship to Ebay's address only. Please make sure your address in EBAY is matched with your shipping address before you pay.PaymentShippingReturnsAbout Us Shipping PaymentShippingReturnsAbout Us Shipping We offer FREE shipping on all orders! Your order will be dispatched within 1 working day of receiving payment (Monday-Friday) and you should expect to receive it 14 - 30 days after dispatch). Your items will be delivered with tracking number. In the very unlikely event that your item is lost or damaged during post, then WE are responsible and will issue either a full refund or replacement.PaymentShippingReturnsAbout Us Returns PaymentShippingReturnsAbout Us Returns If you are not 100% satisfied with your purchase, you can return the product and get a full refund or exchange the product for another one, be it similar or not. You can return a product for up to 30 days from the date you purchased it. Any product you return must be in the same condition you received it and in the original packaging. Please keep the receipt. Buyer pays for returns.PaymentShippingReturnsAbout Us About Us PaymentShippingReturnsAbout Us About Us High quality of the product is the main thesis in the work of our enterprise, the origins of which as a manufacturer of auto electronics go back to the good Soviet eighties. Paying great attention to quality, we do not forget about the price. Working directly with leading domestic and foreign manufacturers of components allows us to offer consumers, in addition to quality, the most reasonable prices. The company SoveK LLC has been represented on the Ukrainian, Russian and Belarusian markets since 2000. For more than 10 years of our history, we have managed to occupy a strong position in the automotive electronics market, gain the authority and trust of numerous customers, including private consumers and corporate users. Since 2007 we have been the only supplier of electronic switches, electronic breaker PE-1 - JSC "MOTOVELO", one of the largest motorcycle manufacturers in the territory of the former USSR. We produce a wide range of electronics products for cars produced by AvtoZAZ, AZLK, VAZ, GAZ, UAZ, ZIL, MAZ, KAMAZ, agricultural and motor vehicles. Recently, the enterprise has mastered the production of a whole range of products for national economic purposes. Having our own high-tech equipment and qualified personnel with experience in development and production allows us to achieve the required quality and reliability of products, to quickly master new products and modernize existing ones.

Price: 72.99 USD

Location: Kyiv

End Time: 2024-09-02T05:05:09.000Z

Shipping Cost: 0 USD