Mission Rubber 2" Heavy Duty No Hub Couplings Cast Iron Pipe Connectors C200HW

Description: 4517SG3C.50 New Mission Rubber 2" (Trade Size) Heavy Duty / Heavy Weight No Hub Couplings for Cast Iron Pipe Connections, Part Number C200HW or C 200 HW. Each bid quantity is for One (1) Coupling. You may bid / buy any number, up to the total quantity available above. These were purchased at an unclaimed freight sale earlier this year, and they were brand new in the original factory case. Note that these are 2" pipe couplings, and that pipe is sized according to its inside diameter. Thus, these will connect pipes with about a 2-3/8" outside diameter. According to the manufacturer: Mission Heavy Weight No Hub Couplings Installation Guidelines These suggestions provide guidelines for the use of the Mission Heavy Weight No Hub Coupling for joining No Hub® pipe and fittings in accordance with accepted industry standards and practices. All construction projects involve many variables. Governing codes, engineering criteria, and the conventions of the plumbing trade, necessitate that judgment decisions must be a combination of design and “on the job” considerations. The following suggestions for joining No Hub® pipe and fittings with the Mission Heavy Weight No Hub Coupling are not definitive, but it is hoped that they will be helpful. Supplementary information about the No Hub® system can be obtained from the Cast Iron Soil Pipe Industry reference publication “Spec. 301-90”, which can be obtained from the manufacturers of No Hub® and Fittings. The Mission Heavy Weight Coupling is designed to be installed by using a properly calibrated torque wrench pre-set at 80 inch pounds. The standard 5/16” hex screw head will accommodate the same tightening tool used on 2 band couplings. 1. In order to provide a sound joint with field cut lengths of pipe, the ends should be cut square. Place the Neoprene gasket on the end of one pipe and the stainless steel clamp assembly on the end of the other pipe or fit- ting to be joined. 2. Firmly seat both ends of the pipe/fittings against the integrally molded shoulder in the center of the gasket. 3. Slide the clamp assembly into position centered over the gasket. At this point, it is recommended to take the “slack” out of each sealing band by pre-tightening the clamps and the wrench to “hand tight”. Final tightening is described below. 4. Mission Heavy Weight coupling size 2” is 3 inches wide and has 4 sealing bands. A. First, tighten the inner bands (a) alternately and firmly to 80 inch pounds. B. Next, tighten the outer bands (b) alternately and firmly to 80 inch pounds.

Price: 9.99 USD

Location: Springfield, Tennessee

End Time: 2024-12-21T20:51:14.000Z

Shipping Cost: 5.49 USD