PETG Case for Lilygo T-Deck

Description: 3D printed using PETG for increased impact resistance and thermal stability, these cases are designed to protect your LilyGo T-Deck and look great doing it. Available in five colors, the case comes complete with all the nuts and bolts needed. Once the on/off switch on your T-Deck (not included) is lined up with the corresponding notch in the provided external switch, the board can be pressed into the front of the case. No screws are necessary to secure the board to the front of the case, only two screws to hold the two halves of the case together. There is a USB C charge port, along with a TF card slot and reset button opening, meaning it is not necessary to open the case to access all of the board's functions. Included is an SMA plug. If you're running an internal antenna it can be left in place, or it can be removed to install an external antenna. The case can accommodate a GPS module up to 16x16x7mm in dimension. The back is deep enough to accomodate a battery as large as a 126090 LiPo battery. There is no battery holder, so double sided foam tape is recommended to secure the battery to the case back. Compatible additional hardware: T-Deck - https://amzn.to/3TsO3nnBattery - https://amzn.to/4cvD0SXGPS Module - https://amzn.to/3TxOi0lLoRa Antenna - https://amzn.to/3xgpeDsFoam Tape - https://amzn.to/4asofi8 Design credit Alley Cat - Printables 741124 - www.printables.com/@AlleyCat_1642919

Price: 22 USD

Location: Littleton, Colorado

End Time: 2024-08-27T17:50:07.000Z

Shipping Cost: N/A USD