Spring Creek Manufacturing DIY Suction Cup Rack Kit

Description: Spring Creek Manufacturing’s Do It Yourself Suction Cup Rack Kit provides all the parts you’ll need to convert a standard 2×4 into a rock-solid rack at an inexpensive price. You will get everything to make ONE rack, including: two suction triangles, a strap for easy attachment, and hardware. (2X4 AND TIE DOWN STRAPS NOT INCLUDED) Directions: To construct your rack, you first have to decide what length 2×4 you will need. If you are going to be hauling wider loads, we would recommend using a 78” 2×4. If you are hauling smaller loads, use a 2×4 that is slightly larger than width of your vehicle. Bolt the suction cup frames to the 2×4’s so the cups are to the outside edges of your roof, by drilling a 3/8” hole (or a little bigger, if you want to remove it later – to allow for wood swelling.) Set the rack on the roof to see where to place the buckles and buckle holders to make sure they are pulling straight down and drill two other slightly over 3/8” holes and bolt on the buckle brackets. Then, place black eye pads on the ends of the 2×4’s where you wish and bolt them on. Black straps must be placed through the cab of vehicle by opening doors and then snugging down securely. This includes hardware to make ONE rack. Spring Creek Manufacturing’s Do It Yourself Suction Cup Rack Kit provides all the parts you’ll need to convert a standard 2×4 into a rock-solid rack at an inexpensive price.You will get everything to make ONE rack, including: two suction triangles, a strap for easy attachment, and hardware.2X4 AND TIE DOWN STRAPS NOT INCLUDED and must be purchased separately. Kit includes ONE RACK. To properly outfit a car, suv, or van without existing rack systems, we recommend TWO RACK Kits. For over the cabs of Trucks with existing bed racks we recommend ONE RACK KitEasily removable with NO drilling into your vehicle required. Removes in just seconds and is in no way permanent on the vehicle. Can be moved from vehicle to vehicle with ease.Anodized Aluminum finish and stainless fasteners prevent rack kit from rust or corrosion. MADE IN THE USA

Price: 115 USD

Location: Mountain Iron, Minnesota

End Time: 2024-02-02T21:10:27.000Z

Shipping Cost: 0 USD