Description: USDR SDR Transceiver All Mode HF Ham Radio 8 Band 80M/60M/40M/30M/20M/17M/15M/10M QRP USB, LSB, CW, AM, FM Transceiver Description: uSDR is optimized and modified based on the open source work uSDX/QCX-SSB. uSDX/QCX-SSB GitHub: https://github.com/threeme3/QCX-SSB/tree/feature-rx-improved This is a shortwave QRP SSB/CW transceiver. The ultra-small size makes it easy to carry for outdoor use. It adopts 1602N LCD screen, built-in speakers. Support to connect to PC and use FT8, JS8, FT4 and other digital mode software control, support CW automatic decoding. Features: - 8 band coverage 80m/60m/40m/30m/20m/17m/15m/10m - Excellent PCB layout design in line with high-frequency circuit design principles to ensure excellent performance - Can reach 3-5W power in 8 bands and reserve TO-220 package pads required for upgrades - High emission efficiency, 80m/60m/40m/30m/20m efficiency is higher than 85%, 17m/15m efficiency is higher than 80%, 10m efficiency is higher than 70% - High-precision for KDS brand TCXO, frequency accuracy is better than 1PPM, frequency stability is better than 0.5PPM - Independent core board and RF board to avoid own signal interference. - Ultra-small size: 83 x 38 x 124mm(excluding protruding parts) - Rich interfaces (CAT, PTT OUT, MIC/KEY, K-head microphone) - All LPF parts use 100V C0G/NP0 capacitors - Use original genuine Omron magnetic latching relay - Use original genuine LM4562 or LM833 op amp chip - Built-in speaker with cavity - BNC antenna interface Function List: - Simple, fun and versatile QRP SSB HF transceiver with embedded DSP and SDR functions - EER Class-E driven SSB transmit-stage - Approximately 5W PEP SSB output from 13.8V supply - All-Mode support: USB, LSB, CW, AM, FM - DSP filters: 4000, 2500, 1700, 500, 200, 100, 50 Hz passband - DSP features: Automatic Gain Control (AGC), Noise-reduction (NR), Voice-triggered Xmit (VOX), RX Attenuators (ATT), TX noise gate, TX drive control, Volume control, dBm/S-meter - SSB opposite side-band/carrier suppression transmit: better than -45dBc, IMD3 (two-tone) -33dBc, Receive: better than -50dBc - Multiband support, continuously tunable through bands 160m-10m (and from 20kHz..99MHz with loss in performance) - Open source firmware, built with IDE for Arduino; allows experimentation, new features can be added, contributions can be shared via Github, software-complexity: 2000 lines of code - Software-based VOX that can be used as fast Full Break-In (QSK and semi-QSK operation) or assist in RX/TX switching for operating digital modes (no CAT or PTT interface required), external PTT output/PA control with TX-delay - Simple to install modification with 8 component changes and 8 wires - Lightweight and low-cost transceiver design: because of the EER-transmitter class-E stage it is highly power-efficient (no bulky heatsinks required), and has a simple design (no complex balanced linear power amplifier required) - Fully digital and software-based SSB transmit-stage: samples microphone-input and reconstruct a SSB-signal by controlling the phase of the SI5351 PLL (through tiny frequency changes over 800kbits/s I2C) and the amplitude of the PA (through PWM of the PA key-shaping circuit) - Fully digital and software-based SDR receiver-stages (optionally): samples I/Q (complex) signal from Quadrature Sampling Detector digital mixer, and performs a 90-degree phase-shift mathematically in software (Hilbert-transform) and cancels out one side-band by adding them - Three independent switchable analog front-end receiver attenuators (0dB, -13dB, -20dB, -33dB, -53dB, -60dB, -73dB) - Receiver Noise level MDS: -135 dBm at 28MHz (in 200Hz BW) - Receiver Front-end selectivity: steep -45dB/decade roll-off +/-2kHz from tuned-frequency - Blocking dynamic range: 20kHz offset 123dB, 2kHz offset 78dB - CW decoder, Straight/Iambic-A/B keyer - VFO A/B + RIT and Split, and corresponding relay band-filter switching via I2C - CAT support (TS480 subset) Package Included: - 1 x Transceiver - 1 x Mic ๏ผNote: it's not including Built-in battery)
Price: 107.84 USD
Location: shenzhen
End Time: 2023-10-09T06:02:04.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Return shipping will be paid by: Seller
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money back or replacement (buyer's choice)
Compatible Brand: uSDR
Frequency Range: 80m/60m/40m/30m/20m/17m/15m/10m
Supported Modes: USB, LSB, CW, AM, FM
Frequency Band Plan: 8 band
Color: Black
Compatible Model: uSDR
Band: AM/FM
MPN: HUSD-8D
Brand: uSDR
Type: Ham Radio Transceiver
Unit Type: Unit
Number of Channels: USB, LSB, CW, AM, FM
Band Type: 80m/60m/40m/30m/20m/17m/15m/10m
Model: HUSD-8D
Features: shortwave QRP SSB/CW transceiver
Country/Region of Manufacture: China
Unit Quantity: 1
Item Weight: 415g
Power: 3-5W